Steel City 20-302, Owner'S Manual, Page: 10 / 20

Page 10
5. Open the lower access door. The drive belt is already
inside, on the saw shaft. Check if the motor pulley is in
line with the saw pulley. If required, loosen the set screw
on the motor shaft so you can slide the motor pulley to
align it with the saw pulley, and tighten the set screw to
lock in place.
6. Choose between one of the two blade speeds offered
(2300 ou 3200 lin.ft./min). Put the belt on the desired
saw pulley and move the belt onto the lower pulley while
slowly rotating the wheel to force the belt in place. Be
careful not to get your fingers pinched.
7. Slide the motor away from the wheel to tighten the belt.
Make sure the belt is tight enough so it won’t come off
or slip on the pulley. Secure the motor mount bolts back
to the saw base.
2300 F.P.M.
3200 F.P.M.
Wheel pulley
Motor pulley
Step pulleys – lower wheel removed for
clarity
◊ ATTACHInG THe TABLe
1. Install the table mount on the saw frame, using 2 hex
bolts. Also install the hex bolt and nut acting as positive
stop, at shown location near the table mount.
Stop
2. With the bolts hanging free through the trunnions, guide
the blade through the slot in the table and turn the table
to guide the bolts into the openings in the table mount.
The table slot for the miter gauge must be on the right
side of the blade. With both bolts in place, install the lock
knobs to secure in position.
3. Install the red insert plate into the opening with detent
in the slot. It is possible that some filing or sanding be
required on the exterior contour of the insert to remove
some excess paint and ease its installation.