Copyright: Steeda Autosports
555-5085
9/25/2012
Assembly of the Steeda Rear Seat Chassis X-Brace
8.
If applicable, secure the dress-up plate to the X-brace with the provided screws and nuts. Use the longer
screws and Nylon lock nuts on the center bolt holes. Use the shorter screws and standard nuts on the
four corners. A small amount of Loctite is recommended for the shorter screws and non-locking nuts.
9.
Remove one of the two Torx screws from each of the rear seat bench brackets, for future use.
Installation of the Steeda X-Brace
10.
Install the brace as seen in figure 3. Reuse the four screws for the backrest striker and two of the Torx
screws from the seat bench brackets. Torque the top mounts to 17 lb-ft and the bottom mounts to 20 lb-
ft. You are done!
