16
Workplace
Important:
Never place this device on or next to hot surfaces (e.g. hot sto-
ves). Only use it on a
even, stable, non-metallic and a heat resisting surface. It is im-
portant that no inflammable items are near to the device. Do
not place the device on the edge of the table so that it cannot be
touched by children or fall down when touched.
Operation:
The appliance is equipped with a touch control display- All functions will be
activated by touching the surface.
Plug the appliance into the socket. A sound can be heard and all LED and the display
are on for one second. Now the appliance is in stand-by modus. Place a suitable pot in
the middle of the cooking area (min. diameter 12cm). When the ON/OFF is touched
for one time a LED bellow heating is on and one LED is on above the ON/OFF .
Attention!!!
After 30seconds the appliance will go back into the stand-by modus,
when no function by touching was chosen.
Power mode
This function is suitable for boiling water and soups.
Place the pot in the middle of the cooking area.
Touch ON/OFF one time and after that the function , the red LED bellow Heating
(Zeichen) is on and in the display there is 1200 is shown. The cooling fan starts work-
ing. With the buttons or can the power be adjusted in steps of 200W. (200Watt
– 2000Watt)
During cooking the Wattage can be changed at any time.
The unit is equipped with an overheat protection. When the pot gets too hot, the
appliance will stop working, a sound can be heard and in the display E02 can be seen.
In that case, press the ON/OFF and cool the appliance down for some minutes. The
appliance will work after that without any problem.
When the failure code E0 is in the display then the used pot or pan is not
suitable induction cookers. The appliance beeps 9 times and after ca 30
seconds the appliance will switch to the stand-by mode.
