ASSEMBLE YOUR STEAM MOP
1.
Remove all the parts from the packaging.
2.
Insert the Ergonomic Handle into the Joining Tube. (Fig.1)
3.
Push it in until you hear it click into place.
4.
Insert the handle assembly into the unit connector.
5.
Make sure that the locking tab snaps into place. (Fig.1)
6.
Place the micro-fiber towel underneath the mop head.
7.
Make sure that the hook and latch strips are facing up. (Fig.2)
8.
Press to secure.
9.
Pulling the Water tank then lift up to remove from unit.(Fig.3)
10.
Turn the cap counter clockwise and then lift up to remove from the water
tank.(Fig.3)
11.
Using the tap water into the water tank. Do not overfill the unit past the
“MAX” fill line on the water tank.(Fig.3)
12.
Replace the cap onto the water tank.
13.
Put the water tank into the unit just the reverse of what the foregoing
operation.
14.
Using your Steam Mop for cleaning floors
IMPORTANT
: Always insure that the unit is “UNPLUGGED” from the wall
receptacle prior to filling and before attaching the micro-fiber towel to the
bottom of the mop head. Never use the steam mop without the micro-fiber
towel attached to the mop head.
NOTE
: When using your new steam mop for the first time you may notice
water residue inside of the unit. Water drops can also be found in the
packaging. This is normal and you should not be alarmed. Each steam mop is
100% tested in the factory to ensure product performance and safety.
Sometimes water is left in the unit from these test procedures.
8
9
Fig.1
Fig.3
STEP 1
STEP 3
STEP 2
Fig.2
