Assembling and Mounting Telescopic Pole
1.
Screw top section of Telescopic Pole (A) onto middle section (B)
(FIGURE 1).
2.
Place Pole Top on top of Telescopic Pole, and rotate it clockwise until
snug (FIGURE 2).
3.
Loosen Top Ridged Knob (C) by turning it counter-clockwise. Pull pole
to extend top section (E) of Telescopic Pole. Tighten Top Ridged Knob
(FIGURE 3).
4.
Repeat step 3 for Bottom Ridged Knob (D) to extend middle section (F)
of Telescopic Pole (FIGURE 3).
NOTE: Telescopic Pole must be fully extended during steamer
operation to insure a free flow of steam through Hose.
NOTE:
Figures 1, 2, and 3 show Telescopic Pole in collapsed position.
5.
Slide ridged base knob onto bottom of Telescopic Pole (FIGURE 4).
6.
Insert bottom of Telescopic Pole into Pole Base (FIGURE 5) in such a
way so that Steam Nozzle Holder faces rear of steamer (see illustration
on page 6). Pointing Steam Nozzle Holder towards rear will ensure
stability of steamer when garments are hanging from Clothes Hanger
Hook.
7.
Push Telescopic Pole down as far as possible.
8.
Turn ridged base knob clockwise to secure Telescopic Pole to Pole Base.
Attaching Hose
1.
Screw Hose onto the threaded Hose Base by turning fitting on end of
Hose clockwise (FIGURE 6).
2.
Hand-tighten only. Do not over-tighten.
3.
Hang Steam Nozzle on specially designed Steam Nozzle Holder as shown
(FIGURE 7).
CAUTION: To prevent steam from causing bodily injury or damage to
surfaces, always hang Steam Nozzle on Steam Nozzle Holder when not
in use. Do not lay Hose on the floor as condensation may occur, causing
unwanted water droplets in steam.
CAUTION: Pulling on Hose with excessive force will damage it,
resulting in a steam leak.
A
SSEMBLY
I
NSTRUCTIONS
8
