ENGLISH | 7
IRONING BOARD
You will need the following pieces to install the Ironing Board:
1.
Insert the Ironing Board Tip into the holes in the front of the Ironing Board Base.
2.
Pull the stand leg of the Ironing Board Base out to a 90 degree-angle. Open the extension
lock on the leg and fully extend. Once fully extended, close the lock so the leg does not
collapse.
3.
Insert the long end of the Cross Bar into the hole in the Stand Leg then screw into place with
the Cross Bar Nut.
4.
Unscrew nut on bottom of stand leg foot. Install cross foot and secure by screwing nut back
onto stand leg foot. Insert the short end of the Cross Bar into the hole in the Ironing Board
Base. Turn the Station upright.
5.
Attach the Ironing Board to the Telescopic Poles using the Side Screws.
6.
Place Ironing Board Cover over the Ironing Board and squeeze clip attached to the
drawstring with one hand while pulling the string tightly with the other to ensure a snug fit.
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
Ironing Board Base, Ironing Board Tip, Cross Bar
Ironing Board Cover, Side Screws, Stand Leg Foot, Cross Bar Nut
