+44 (0) 1329 239 679
www.steam-e.com
GUM REMOVER
Operating Instructions - June 2018
Operations continued
STEP 1: Pre-run set up
Make sure that the battery is fully charged.
Connect the handle plug to the socket on the main unit.
STEP 3: Attach a brush to the nozzle
A brass brush should be used for cleaning hard or urban
surfaces. Brass brushes can be used on concrete, asphalt
(tarmac), stone, block paving, sports surfaces, marble and
other hard surfaces.
Note:
If you are not certain if a brass brush may scratch
the surface being cleaned, we recommend using a nylon
brush instead.
A nylon brush should be used for cleaning carpets, mats,
upholstery and surfaces, which could be scratched by using
a brass brush.
STEP 2: Assemble the heating assembly
For a short hand-held wand, attach the heating assembly
directly to the handle.
For a longer wand, attach extension tube(s) onto the handle
and then attach the heating assembly onto the extension
tube(s).
Make sure that the internal connectors are aligned before
fastening the screw collars. These can only be inserted
correctly one way.
Note:
Do not over-tighten the connection collars on each
of the extension tubes.
FOR SAFETY:
A maximum of two extension
tubes can be used.