Continued on Next Page
SB-VW-CC/10W3v3 INSTR_SKU# 011333
Page 3 • JL Audio, Inc., 2012
S T E P 1 5
Attach speaker cable to the enclosure, and set it into position
on top of the spacer as shown.
S T E P 1 9
Place a 1/4” Flat Washer over a 1/4 - 20 x 1” Bolt, and slide the
bolt through the square hole in the brace from the back,
then through the hole in the Top Bracket. Thread a 1/4” Flat
Washer, a 1/4” Lock Washer, and a 1/4 - 20 Hex Nut onto the
bolt as shown, and firmly tighten.
S T E P 1 4
Pictured is the spacer for the Stealthbox®. Place the spacer
into the Stealthbox® location, aligning the four holes with the
four studs in the floor of the trunk.
S T E P 1 8
Locate the square hole indicated in the brace near the trunk
lid hinge.
S T E P 1 3
Remove the driver’s side trunk liner.
S T E P 1 7
Secure the Top Bracket to the Stealthbox® using a 1/4 - 20 x
1” Bolt, a 1/4” Lock Washer, and a 1/4” Flat Washer as shown.
S T E P 1 2
Fold the rear seat back down. Carefully unclip the bolster
and remove it from the vehicle. Pictured is the back side of
the bolster to show the location of the clips. Repeat
Steps
11-12
for the passenger side.
S T E P 1 6
Secure the Side Bracket to the Stealthbox® using a 1/4 - 20 x
1” Bolt, a 1/4” Lock Washer, and a 1/4” Flat Washer as shown.
Secure the Side Bracket to the floor using the factory nut as
shown.
