Continued on Next Page
SB-F-150/10W3v3_INSTR_SKU#011227
SB-F-150/10W3v3_INSTR_SKU#011227
S T E P 6
Lower the Stealthbox
®
onto the floor and firmly press
down.
Remove the Stealthbox
®
out of the vehicle carefully, leav-
ing the wax square in place. The socket cup set screws will
leave an impression in the wax. The socket cup set screw
will leave an impression onto the wax.
S T E P 5
Position the Stealthbox
®
into the mounting location.
Guide the side socket cup set screw through the existing
hole in the rear seat bracket. The Stealthbox
®
needs to fit up
against this seat bracket.
S T E P 4
Thread in a supplied socket cup screw into the side insert of
the Stealthbox
®
, leaving 1 1/2-inches exposed.
Page 2 • JL Audio, Inc 2006
S T E P 8
Back out the bottom socket cup set screw installed in
Step 3
, leaving 1 1/2-inches of thread exposed.
S T E P 9
Cut enough speaker wire to allow the run from the
Stealthbox
®
location to the amplifier location.
Attach the speaker wire to the wire terminal on the
Stealthbox
®
. Check the woofer for proper operation.
S T E P 7
Note: Before drilling, make sure that you are not going
to be drilling into any gas lines, brake lines, transmission
lines, electrical wiring, transfer case (4x4 vehicles)
or anything else that might cause a reduction in your
weekly pay. Always wear eye protection when drilling!
With a drill and a 1/2-inch drill bit, drill through the
impression made in the wax square and into the vehicle’s
transmission hump. Once the drill bit breaks through the
metal floor, do not force it any more. A cross-member runs
on the outside under the floor. Remove the wax square and
cut the carpet from the area around the drilled hole.
