Stealth Cam STC-G42NG-KPT, Instruction Manual

Page: 11 / 54

www.stealthcam.com Page
877-­‐269-­‐8490
11
CAMERA PROGRAMMING -­‐ CUSTOM (CONT)
o
PIR PHOTO (default): In this mode the camera will take a designated amount of picture with
a designated time out when the camera senses activity in front of the unit. This mode is
available for both day and night activities.
"
PHOTO RES – 6.0 MP (default): This setting is used to determine the Megapixel resolution of each
image taken by the camera. With this option blinking, use the UP or DOWN arrow key to move
between the options of: 14MP, 8MP, 6MP or 2MP. The higher the resolution of an image the more
space the file will take on the SD memory card.
"
PIR DELAY – 00min 05sec (default): This setting is used to determine the length of the time that the
camera will wait before it reinitializes its PIR sensor for the next activation. With the TL mode this
setting is only active if TL Delay is set to 1 min or greater. This setting can be changed between the
numbers of 00min 05sec to 59min 59sec. With this option blinking, use of the UP and DOWN
arrows will allow the minutes setting to be changed from 00 to 59. Once this setting is on the
appropriate minutes, press the RIGHT arrow key to move to the seconds setting and it will start to
blink. Use of the UP and Down arrows will allow the seconds setting to be changed from 00 to 59
(05 to 59 if minutes = 00).
"
PIR RANGE – STANDARD (default): This setting allows you to control the sensitivity distance the PIR
will be activated. These distances can vary depending on environmental conditions. This setting will
change between EXTENDED which will trigger about 1/3 further than the STANDARD setting, the
STANDARD setting, or NEAR FIELD that will only trigger on movement closest to the camera.
"
REDUCE BLUR – ADVANCED (default): This setting is used to determine if the camera should use the
MATRIX Blur reduction technology to dramatically reduce the blur effect resulting in clearer night
time infrared shots. (STANDARD) Minimizes blurring effect in images whlle retaining long-­‐range
night image capability. (ADVANCED) Maximum blur reduction achieved through a faster shutter
speed. This setting my cause a slight reduction in night time range and increased grain in the image.
With this option blinking, pressing the UP or DOWN arrow buttons will cause the camera to cycle
between the two options of STANDARD or ADVANCED.
"
PHOTO BURST – 1 PHOTO (default): This setting is used to determine the number of photos the
camera will take during its activation. This setting can be changed between 1 PHOTO up to 9
PHOTOS. With this option blinking, use the UP or DOWN arrow key to move between the value
range in increments of 1.