FRONT PANEL PROGRAMMING
While using SSMS software programming is preferred for quickly adjusting the DSP functions, you may also perform
all DSP programming from the front panel buttons as well as adjust other parameters like input routing, pre/post DSP
pass through settings, input defaults and front panel display brightness. Please refer to the front panel diagram for the
location of the following Menu and Menu Navigation buttons:
Main Menu
Button - Accesses the front panel menu structure; select individual channel, or both channels together
for programming.
Menu
Navigation Buttons - Steps through the available menu items.
Enter/Ok
Button - Selects the displayed menu item.
Return
to Previous Menu Button - Reverts to the previous Menu item. Multiple presses exits the menu, returning the
display back to normal operation.
Below are non-DSP programming features of the SA2400. These and certain other functions are accomplished only
from the front panel buttons. See the
Programming Menu - Front Panel Navigation
diagram in this document for
complete menu programming options.
Setup Menu - Input Assign
Input routing and other non-DSP “Utility” functions are accomplished via the front panel menu buttons under the
Setup/Input Assign menu (see
Programming Menu - Front Panel Navigation
diagram). You may assign any physical
input channel to either or both amplifier channels. This allows for functions such as “mono-summing” of the stereo
inputs into two mono signals, or to map inputs to different outputs.
Default assignment is: Chnl1=Chnl1; Chnl2=Chnl2.
Pass Through Output Assign
Selects whether the line level pass-through outputs are tapped before or after the DSP stage. When in “Pre-DSP”
(default) mode, the pass through outputs are unaffected by DSP programming. In “Post-DSP”, any DSP programming
of input signals is sent to the line-level output jacks.
Default setting is “Pre-DSP”.
DSP Presets
10 internal DSP presets may be recalled and saved using the front panel buttons, or via IR commands. Factory settings
for optimizing Stealth speakers are pre-installed in the presets, which may be altered, renamed and re-saved depending
on need. See
Internal Presets
section for more details on DSP presets.
Display Brightness
The front panel LCD display brightness is adjustable as “Bright” or four levels of “Dim” to suit the installation needs.
Utility Functions
A built in Pink Noise Generator is available under the Utility menu, as well as firmware version information and factory
default settings.
Auto Input Sensing
The amplifier may be set to automatically detect an Optical or Analog input, or to amplify only the Analog, or Digital
Optical inputs.
Default = Auto
(amplifier auto detects optical signal presence).
IR CONTROL
Master Volume and Internal Preset recall my be remotely controlled via IR commands, using the front panel IR target
and an IR compatible remote control or control system.
IR HEX command strings are available at StealthAcoustics.com/sa2400-mkii
