BEFORE YOU BEGIN
1.
2.
3.
4.
Read the manual, help files, and other files on the C:\EsdTest directory.
Install the meter in view, so employees that are testing can view the test results.
Take a deep breath, and know that with the innovative product line of Static Solutions there is instant peace of mind.
At anytime, please contact Static Solutions technical staff or refer to
for technical support literature.
Technical questions should be directed to
METER ASSEMBLY INSTRUCTIONS
Fasten the foot stand to the footplate. Place the foot stand on top of the footplate. Insert the small Allen head bolts through the
1.
2.
3.
4.
5.
6.
holes in the circular plate on the bottom of the stand. Position these bolts into the T nuts located in the bottom of the footplate
using the enclosed Allen head wrench. Tighten with Allen head wrench.
DO NOT OVER TIGHTEN.
Insert the cords and wires inside the back of the foot stand allowing wire slack. Place the enclosed plastic shroud over the wire
enclosure.
Do not install an alkaline battery if the power supply is used.
IT MIGHT OVERHEAT AND RUPTURE. Use only the power
supply
OR
the alkaline battery. You may use a rechargeable battery if desired.
Plug the footplate lead completely into the tester socket "Heel Plate"
Plug in the power supply.
Remove the protective film from both the metal plates on the footplate. Clean the plates with only alcohol and NOT a antistatic
cleaner
BEFORE YOU BEGIN
1 Read the manual, help files..
2. Install the meter in view, so employees that are testing can view the test results.
3. Take a deep breath, and know that with the innovative product line of Static Solutions there is instant peace of mind.
4.
At anytime, please contact Static Solutions technical staff or refer to
for technical support
literature. Technical questions should be directed to
. Fasten the foot stand to the footplate.
Place the foot stand on top of the footplate. Insert the small Allen head bolts through the holes in the circular plate on the
bottom of the stand. Position these bolts into the T nuts located in the bottom of the footplate using the enclosed Allen head
wrench. Tighten with Allen head wrench.
DO NOT OVER TIGHTEN.
5. Insert the cords and wires inside the back of the foot stand allowing wire slack. Place the enclosed plastic shroud over the
wire enclosure.
6.
Do not install an alkaline battery if the power supply is used.
IT MIGHT OVERHEAT AND RUPTURE. Use only the
power supply
OR
the alkaline battery. You may use a rechargeable battery if desired.
7. Plug the footplate lead completely into the tester socket "Heel Plate"
Plug in the power supply.
8. Remove the protective film from both the metal plates on the footplate.
9. Fasten the foot stand to the footplate. Place the foot stand on top of the footplate. Insert the small Allen head bolts through the
holes in the circular plate on the bottom of the stand. Position these bolts into the T nuts located in the bottom of the footplate
using the enclosed Allen head wrench. Tighten with Allen head wrench.
DO NOT OVER TIGHTEN.
10. Insert the cords and wires inside the back of the foot stand allowing wire slack. Place the enclosed plastic shroud over the
wire enclosure.
11.
Do not install an alkaline battery if the power supply is used.
IT MIGHT OVERHEAT AND RUPTURE. Use only the
power supply
OR
the alkaline battery. You may use a rechargeable battery if desired.
12. Plug the footplate lead completely into the tester socket "Heel Plate"
Plug in the power supply.
13. Remove the protective film from both the metal plates on the footplate.
Static Solutions CT-8700 Combo Tester Instructions
6/22/2008
