④ Wipe off any dirt on the workspace with a rag etc. containing alcohol. If you cannot remove fine
dirt, you can also blow it clean with compressed air etc.
⑤ Re-attach the perforated floor (the side with black rubber attached should face toward you).
⑥ Insert the knurled screws in the sides of the main unit.
• If you do not reinsert the knurled screws the photoelectric sensor may not operate correctly.
9. Troubleshooting
• The power will not turn on.
→ Check that the wiring and power supply are set up correctly.
→ The fuse may be blown. Check the fuse box in the rear side of the main unit.
*Compatible fuses are Φ6.4 x 30mm, 250V, 10A.
• Air blow doesn’t occur.
→ Check that the compressor air is being supplied correctly.
→ Check that the regulator of the device is adjusted correctly.
→ Check whether the ‘ALARM’ - ‘ION’ or ‘FAN’ lamp is illuminated.
• The neutralizing effect is unsatisfactory.
→ Check whether the emitter pin or its surroundings are dirty.
→ Check that the ground of the device is reliably grounded.
→ Check that there is no water or oil in the compressed air being supplied to the device. (Check
that conditioners such as an air filter and dryer are attached.)
• ‘ALARM’ – ‘ION’ is illuminated.
→ Check whether the emitter pin or its surroundings are dirty.
→ Check that the ground of the device is reliably grounded.
→ Check that there is no source of noise in the vicinity of the device.
• ‘ALARM’ – ‘FAN’ is illuminated.
→ Check that no foreign objects are in the fan portion of the main unit.
10. Options
• Replacement 10-micron exhaust filters (x5): p/n PTCFLT
• Replacement 5-micron filter/regulator element: p/n AF40-060S
• Replacement 0.3-micron secondary filter element: p/n AFM40P-060AS
Please contact us if you have any questions or concerns, at:
STATIC CLEAN INTERNATIONAL
www.staticclean.com
※
(877) 782-8423
※
R
Ver.2 20200924
8
