State Water Heaters SCE 65-400, Installation, User And Service Manual

Page: 50 / 72

Controls
50 Instruction Manual SCE
5
gis
5.8 Flue gas outlet cut-
out reset button
A fault in the flue gas outlet, for example, due to a blockage of the flue gas outlet
duct, can result in the flue gas thermostat locking out. This state can be
recognised by the fact that the push button for the flue gas thermostat has been
activated, see
Figure 5.3 . After removing the cause, you can press this push
button if the sensor has cooled down sufficiently (if you do not allow the sensor
to cool down sufficiently, the flue gas thermostat will once again lock out
immediately). After this the appliance is automatically put back into operation
when there is a heat demand. Should this not be the case, then see chapter
’8 Faults’ for a more detailed overview of the fault.
Figure 5.3 Flue gas cut-out reset button
IMD-0151