State Water Heaters SCE 65-400, Installation, User And Service Manual

Page: 49 / 72

Burner controller reset button
Release R.1.0 Uk 49
gis
5.6 Burner controller
reset button
A fault can result in the burner controller locking out. Where this is the case, the
red LED on the control panel illuminates. After the cause of the fault has been
removed, you can reset the appliance by pressing the reset button.
n
Remark
Before resetting, always first remove the cause of the fault.
See chapter ’6 Status of the appliance’ on how to detect various faults. How to
rectify faults is described in chapter ’8 Faults’ .
5.7 Week timer
switching
You can use the optional week timer to set the desired periods during which the
appliance is to meet the heat demand. Set the I/0/II switch to the 'II' position to
activate the week timer circuit.
There are seven day segments on the week disk
b
on the timer
a
: ‘Monday’ to
‘Sunday’. Each day is divided into 12 tabs
f
(2 hours per tab).
In order to set a time period during which the appliance is to meet the heat
demand, the tabs must be pushed outwards.
The current time can be read from the hands
d
(12 hour).
Set the day and time as follows: to set roughly, turn the week disk in the direction
of the arrow until the desired day is aligned with the marker arrow; for fine
setting, turn the pointer clockwise until the correct time is aligned with the
marker arrow. The manual switch
e
must always be in the central position (the
timer program is then active).
Legend:
a
timer
b
week disk
c
marker arrow
d
hands
e
manual switch
f
tabs
Figuur 5.2 Week timer
a
b
d
e
f
c