State Water Heaters SCE 65-400, Installation, User And Service Manual

Page: 34 / 72

Installation
34 Instruction Manual SCE
3
is
3.11.1 Introduction
If the appliance has to operate on some gas family (LP-gas or natural gas)
other than the category of gas for which the appliance has been set up as
standard, the appliance should be adapted using a special conversion kit.
The conversion of the SCE 65-500 differs from the other SCE-appliances. The
conversion procedures are described in the paragraphs:
•
’3.11.2 Conversion to another gas category SCE 80-115 to 65-400 incl.’
• ’3.11.3 Convert to another category of gas SCE 65-500’ .
3.11.2 Conversion to another gas category SCE 80-115 to 65-400 incl.
(80-115, 80-140, 80-180, 95-199, 95-260, 70-360, 65-400)
1. Disconnect the appliance from the mains. See paragraph
’7.3.2 Disconnecting the appliance from the mains’ .
2. Switch off the gas supply.
Remember
The burner may be
hot.
3. Screw the cover plate
a
from the burner support.
4. Use a suitable tool to remove the blocking strips
b
. The blocking strips in
fact have sharp edges.
Completely pull off the blocking strips.
n
Remark
The radiation shield / the condensation tray can be temporarily loosened to
simplify assembly of the burner.
Legend
a
cover plate
b
blocking strip
c
injector with stamped figures
Figure 3.7 Replacing injectors
1
2
3
IMD-0126