
3
If using a 5mm drive, place the two foam pads on the bottom of the drive
3.
tray. The foam pads are not required if using an 8mm drive.
Place the drive into the tray and then slide the drive onto the connector.
4.
Replace the top cover. The plastic pull tab may be removed, if desired.
5.
Replace the screw in the rear panel.
6.
Connect the USB cable from the enclosure to the computer system.
7.
Driver Installation
No driver installation is required for any operating system that supports
USB, as this enclosure uses native drivers that are already installed.
Pull Tab
Foam Pads