3
Hardware Installation
Remove the drive trays from the enclosure, by pressing the release
1.
button, then pushing down on the arms to eject them and slide the
trays out.
Remove the brace from the trays, then secure the hard drive into the
2.
trays with the supplied screws.
Slide the trays back into the enclosure until they are fully seated,
3.
then close the arms.
Set the dip switches on the rear of the enclosure, for the proper
4.
mode you want to use.
Plug in the power adapter and press the power button on the front.
5.
Press the SYS reset button on the unit, to make sure it’s configured
6.
for the proper mode.
Plug in the USB or eSATA cable, and the connect the other end to
7.
the computer system.