17
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
3.
Flip the front door so that the levers are located on the
opposite side.
4.
Position the front door so that the top and bottom levers are
aligned with the washers located in the hinge area of the
enclosure.
5.
In the top corner of the front door, pull the lever down and
release it into the washer and hole in the enclosure.
6.
In the bottom corner of the front door, pull the lever up and
release it into the washer and hole in the enclosure.
Adjust the Depth of the Mounting Rails
The mounting rails come pre-installed in the enclosure. The
mounting rails can be adjusted independently in 3/4 inch (20
mm) increments to accommodate different sizes of equipment.
Note:
Do not attempt to adjust the mounting rails when
equipment is installed in the enclosure. Remove the equip-
ment first before you adjust the mounting rails.
1.
Each of the mounting rails is connected to the enclosure
with a screw and cage nut in the upper and lower corners of
the mounting rail. Use a Phillips type screwdriver to remove
the screws and cage nuts from the mounting rails.
2.
Install the cage nuts at the desired depth.
3.
Slide the mounting rail to the depth of the cage nuts and use
a Phillips type screwdriver to install and tighten the screws
that you removed in step 1.
