17
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
Adjust the depth of the mounting rails
The mounting rails come pre installed in the enclosure. Both
the front and back set of mounting rails can be adjusted
independently in 3/4 inch (20 mm) increments.
Warning!
Do not attempt to adjust the mounting rails when
equipment is installed in the enclosure. Remove the equip-
ment first before you adjust the mounting rails.
1.
Each of the mounting rails is connected to the enclosure
with a screw and cage nut in the upper and lower corners of
the mounting rail. Use a Phillips type screwdriver to remove
the screws and cage nuts from the mounting rails.
2.
Install the cage nuts at the desired depth.
3.
Slide the mounting rail to the depth of the cage nuts and use
a Phillips type screwdriver to install and tighten the screws
that you removed in step 1.
Move the Mounting Rails