Instruction Manual
2
Installation
WARNING!
PCI Express cards, like all computer equipment, can be severely damaged
by static electricity. Be sure that you are properly grounded before opening your
computer case or touching your PCI Express card. StarTech.com recommends that you
wear an anti-static strap when installing any computer component. If an anti-static
strap is unavailable, discharge yourself of any static electricity build-up by touching a
large grounded metal surface (such as the computer case) for several seconds. Also be
careful to handle the PCI Express card by its edges and not the gold connectors.
Hardware Installation
1.
Turn your computer off and any peripherals connected to the computer (i.e. Printers,
external hard drives, etc.). Unplug the power cable from the rear of the power
supply on the back of the computer and disconnect all peripheral devices.
2.
Remove the cover from the computer case. See documentation for your computer
system for details.
3.
Locate an open PCI Express slot and remove the metal cover plate on the rear of the
computer case (Refer to documentation for your computer system for details.). Note
that this card will work in PCI Express slots of additional lanes (i.e. x4, x8 or x16 slots).
4.
A second expansion card slot cover will need to be removed to accommodate the
second expansion bracket for the card.
5.
Connect the two 10-pin IDC connectors from the second expansion
bracket to the headers on the card. The headers are marked with
an arrow on the board to indicate where the red wire on the cable
should be located.
6.
Insert the card into the open PCI Express slot and fasten the bracket to the rear
of the case. Fasten the second expansion bracket for the card to the other open
expansion card slot.
NOTE:
If installing the card into a small form factor/low profile system, replacing the
pre-installed full profile brackets with the included low profile installation brackets
may be necessary. 4 adjacent low profile expansion card slots will be required in the
computer chassis/case.
7.
Place the cover back onto the computer case.
8.
Insert the power cable into the socket on the power supply and reconnect all other
connectors removed in Step 1.
