Installing the Drivers
Windows 98/98SE/ME
1. Windows will detect that new hardware has been installed and launch the Add New
Hardware Wizard. Click Next and choose the Search for the best driver for your
device (Recommended) option. Click Next. Ensure the installation CD is inserted.
2. On the next screen select only Specify a location. Choose Browse.
3. In the file selection box, double click this folder under your CD-ROM:
Sil_SATA_10034. Click OK.
4. The file location box under Specify a location will now contain the path to the files.
Click Next.
5. The Wizard will inform you that “Windows is now ready to install the best driver for
this device...” Click Next. The Wizard will complete the installation. Click
Finish.
6.
If the Add New Hardware Wizard appears again, repeat steps 1 through 5 above to
complete the installation.
Windows 2000/XP
1. Windows will launch the Add New Hardware Wizard. Click Next.
2. Choose the Search for a suitable driver... option and click Next.
3. Check only the CD-ROM drives option. Ensure the installation CD is inserted in
the CD-ROM or other optical drive. Click Next..
4. Windows will display a message stating that “Windows has found a driver for this
device”. Click Next. Choose Yes or Continue Anyway if you are warned that the
driver file has not been digitally signed.
5. WIndows will display a message that states “Windows has finished installing software
for this device”. Click Finish.
6. Windows will continue to detect and install any remaining new devices. If the Add
New Hardware Wizard is launched again, repeat steps 1 through 5 from above.
Verifying Your Installation
Windows 98/98SE/ME
1. Go to Start > Settings > Control Panel.
2. Double click System.
3. Click the Hardware tab.
4. If the card does not appear with a red x or yellow exclamation point (!) next to it,
Windows has not detected a problem with the installation and the card should
function normally.
Instruction Manual
3
Summary of Contents for PCISATA2
Page 10: ...Revised 22 November 2004 Rev B...
