over the screwheads. Slide the case downward so that the screwheads slide into
the narrow slots.
6. Connect one end of your network cable to an open port on the rear panel of the
switch.
7. Plug the other end of the cable into the RJ-45 port on your network device.
8. Repeat steps 5 and 6 for any other devices you want to connect.
9. Plug one end of the the power adapter into an open outlet and plug the other
end into the DC connector on the side panel of the device. The
Power
LED on
the front of the switch should now be lit.
10. Once the Switch is powered on, it will be automatically initialized, and all
Link/Act LEDs will flash momentarily, indicating that the system has been reset.
Power LED
Front Panel
Port Link/Activity LEDs
The LED indicators are used for monitoring and troubleshooting of the Switch:
Power LED
: This indicator will light up when the Switch powers up. If the LED is
not lit, please check the power adapter and connection.
LINK/ACT LEDs
: These LEDs indicate Link/Active status. One LED indicator will
light green when a device is connected to the corresponding port. It flashes when
data is being transmitted or received on the connection.
Instruction Manual
3
