Instruction Manual
3
Installation
Hardware Installation
1. Place each VDSL Extender unit at their respective end-point locations. Make sure an
AC electrical outlet is located nearby.
2. Connect the included power adapters to the pair of VDSL Extender units. The Power
LED should light up solid.
3. Connect the “Line” RJ11 connector on the VDSL Extender units either directly
together with patch cabling, or to a buildings existing analog telephone wiring. If
the two units are able to successfully communicate with each other, the “WAN” LED
should light up solid.
OPTIONAL:
If the telephone wiring is also used for POTS telephone service, then a
telephone may be connected to the “Phone” RJ11 connector on the VDSL Extender units.
4. Connect each computer, or Ethernet networking device to an available RJ45
connector on the VDSL Extender units. The respective LAN LED should light up to
indicate a successful physical connection.
Driver Installation
No driver or software installation is required.
Configuration
Web Interface
Each of the VDSL Extender units have a built-in web interface, for configuring the
router settings (WAN and LAN ports), if necessary. The interface can be access via
their IP addresses (
CO Modem: 192.168.16.249, CPE Modem: 192.168.16.250
). The
default password is: admin
The main menu screen on the CPE Modem has two options: “Setup Wizard” for quick
setup, and “Advanced Setup” for a more customized configuration. The CO Modem
only has “Advanced Setup” options.
