StarLeaf Pronto Cable USB 4100 Read This First Download Page 2

Page: 2 / 2

1. Slide off the mounting

bracket from Pronto.

2. Slide open Pronto and

remove the cover.

8. Connect the straight USB-A connector of the alternative cable to the top USB port on the rear of the room system codec.

3. Remove the two cable restraints from Pronto and set aside.

4. Remove the micro USB-B cable from Pronto and replace it with the

alternative micro USB-B cable that has a USB-A connector at the

other end.

5. Replace the two cable restraints

tight against the connector end

ensure that the cable remains in place

. You can fit the restraints in

either orientation to get the best hold.

6. Replace the cover of Pronto.

7. Slide Pronto back into the mounting bracket (if you require this).

480-00320

Option (B) Install Pronto with a StarLeaf Touch 2035 or room system codec

If you have a Touch 2035 you must connect Pronto directly to the room system codec. To do this, you must first remove the angled

micro USB-B cable that is fitted to Pronto and replace it with the alternative USB-A cable. Follow the instructions below.

USB-A

Summary of Contents for Pronto Cable USB 4100

Page 1: ...tructions For a Touch 2035 you must connect Pronto directly to the room system codec Follow Option B instructions overleaf Pronto comes with an angled micro USB B cable fitted Angled micro USB B Micro...

Page 2: ...o cable restraints tight against the connector end to ensure that the cable remains in place You can fit the restraints in either orientation to get the best hold 6 Replace the cover of Pronto 7 Slide...