Before installing Pronto 210, read the safety and compliance information at:
support.starleaf.com/safety
All the components and cables you need for this installation are included in the box
Pronto Cable USB
Hub 20
HDMI
Ethernet
USB-A
USB-A
Network
Power supply
Room screen
Keypad
How to install Pronto 210
1. Screw both antennas into
Hub 20
. If you want to place
Hub 20 behind a room screen, make sure that there is
enough space
2. Connect the network, room screen, and keypad to
Hub 20
. Connect
Pronto Cable USB
to enable wired
sharing for your meeting room
3. Connect the power supply to
Hub 20
. It may take a
few minutes to initialize
4. Enter the QuickConnect code using the keypad. To
generate the QC code, admins must add
Hub 20
to
their StarLeaf Portal
5. When provisioning is complete, your room screen will
display the idle instructions screen until content is
presented
Antenna
Antenna
How to generate a QuickConnect code
1. Go to the
Room Systems
page on your Admin portal
and click
Add room system
2. Complete all required fields and ensure you select
StarLeaf Hub 20
in the
Hardware endpoint
section
3. Click
Apply.
The QC code appears in the
Hardware
endpoint
section
StarLeaf Pronto 210
Installation Guide
For more help with any StarLeaf product, go to:
support.starleaf.com
Copyright © StarLeaf March 2020
