DaVinci-II Aprilia RSV4-APRC / RF Note
Installation and user manual.
INSTALLATION
Your DaVinci-II for Aprilia RSV4-APRC comes with a plug&play loom which allows the direct connection without any modification to the original
harness of the bike.
1.
Remove the original dashboard.
2.
Position DaVinci-II making, on the original front frame of the bike, the three holes for the silent block supports, as per DaVinci-II user
manual.
3.
Connect DaVinci-II to the bike harness using the loom adaptor supplied in the package. The cable labelled “CAN” is only required to
connect any possible Starlane optional modules such as, for example, the RID LAMBDA module (code RID1LRT)
for carburation .
4.
If you also want to detect the TPS signal (throttle position), connect the
YELLOW
wire (supplied) by soldering it to the
YELLOW-BLACK
wire which goes to pin 48 of the large connector of the ECU. If you want the signal from the grip instead, the wire is
LIGHT BLUE
on pin
13 of the same connector.
We suggest to connect to the GRIP signal because it’s also easier to calibrate,
if, on the other hand, the data is
to be used for carburation, it must be connected to the TPS.
OPERATING AND SETTING
DaVinci-II RSV4-APRC receives directly from the Can Bus Line of the bike all the main signals (RPM, Wheel Speed, Engaged Gear, Water
Temperature, Neutral, etc.) in addition to values of Engine Map, Traction Control, ABS, Launch Control and Wheelie.
ENGINE MAP AND TRACTION CONTROL
The engine Map and Traction Control values selection will be done through the original handlebar buttons.
SETTING LAUNCH CONTROL, ABS AND WHEELIE
As like as on the original dashboard you can set the desired Launch Control and
Wheelie and ABS (if present) values:
1.
Enter the
APRC
menu by pressing the
and
buttons on the bike left
handlebar.
2.
As soon as the first screen appears on the right, immediately release the
buttons to access the
APRC
menu.
N.B .: This screen is the same that will be used on the track to activate the
Launch Control, simply by keeping pressed the buttons until the message
disappears automatically. The appearance of the word "
Launch
" in the lower
bar of the display will indicate that Launch Control is active at that moment.
3.
Select the setting you want to modify by pressing the
keys on
DaVinci-II dashboard.
4.
Press the
ENTER
key on DaVinci-II to enter the editing mode for the selected
field.
5.
Press the
and
buttons on the original handlebar to set the desired
value.
6.
When done press
CANC
key on DaVinci-II to confirm and exit.
APRC TIRE CALIBRATION
DaVinci-II RSV4-APRC allows to perform the automatic tire calibration procedure as
like as the original dashboard.
1.
Enter the
APRC
menu.
2.
Select “
APRC Calibration
”, by pressing
Enter
, the system will return to the
main screen in Calibration mode showing the “
CALIBRATING…
” label.
Perform the calibration on road as explained in the original user manual of your Aprilia RSV4-APRC.
When complete, the “CALIBRATING” label will automatically disappear.
Starlane
s.r.l. Via Madonna delle Rose, 70 - 24061 Albano S. Alessandro (BG) - Italia e-mail: