Attach the grader’s hydraulic hoses.
Make sure you always connect the
same cylinder’s hoses to the same tractor hydraulic valve, and not cross
them.
Lift and lock the grader’s support leg.
ENSURE that all the locking pins and cotters are intact!
3.1 Measures after the first 50 hours of use
When the new grader has been used for 50 hours, the following
measures must be undertaken:
•
Tightening the bolts between the steel frame and rotating frame
(8 x M16 8.8 hex screws. Pre-tightening first 72.5 nm, for final
torque of 210 nm)
(the bolts are shown in the picture below).
Figure 2. Bolts between steel frame and rotating frame
•
In addition, in models with a mechanical body rotation, i.e. TLM
graders: tighten the locking plate and tractor triangle mounting
bolts (8 x M16 8.8 hex screws. Pre-tighten 72,5Nm, the end of the
tightening 210nm) (Bolts are shown in the pictures below)
Summary of Contents for TLH2500
Page 3: ......
Page 32: ...Picture 10 Safety valve ...