StarForm Swift-G OI-G1480, User Manual, Page: 82 / 84

set to On.
• Software . Specifies that the trigger source will be generated
by software using the TriggerSoftware command.
•
Line0 . Specifies which physical line (or pin) and associated
I/O control block to use as external source for the trigger
signal.
8.2.77 TriggerWaitMode
Name
TriggerWaitMode
Category AcquisitionControl
Interface IEnumeration
Access
Unit
-
Visibility Beginner
Values Pause, Run
Specifies camera action when waiting for a trigger.
•
Pause . Specifies that the acquisition cycle is paused waiting
for a trigger (no-illumination). In order to allow the camera to
run internal calibration routines and maintain accuracy the
trigger should be supplied periodically.
• Run . Specifies that the acquisition cycle keeps running and
the next burst of frames completed after a trigger is returned.
8.2.78 UserOutputSelector
Name
UserOutputSelector
Category DigitalIOControl
Interface IEnumeration
Access Read/Write
Unit -
Visibility Expert
Values UserOutput0
Selects which bit of the User Output register will be set by User-
OutputValue
.
•
UserOutput0 . Selects the bit 0 of the User Output register.
74 of 76