MR2-B31BP Series User Manual
5
6. Description of HDD Indicators
Status
HDD Status Light
RAID 0, BIG
RAID 1
JBOD
HDD idle
Blue light always on
Blue light always on
Blue light always on
No HDD detected
Red light always on
Red light always on
Red light always on
Data access
Blue light flashing
Blue light flashing
Blue light flashing
Rebuilding data -
Source HDD
N/A
Breathing Blue Light
N/A
Rebuilding data -
Target HDD
N/A
Breathing Purple Light
N/A
7. Hard Drive Replacement and Data Rebuild Instructions
1. During the use of MR2, if you are required to replace a malfunctioning drive, refer to chapter
4“Hardware Installation”. Once drive replacement is completed and it is turned on, MR2 will perform
data rebuilding procedure automatically.
2. If, during the rebuilding process, a drive malfunctions and is unable to continue the rebuilding process,
please restart MR2 to check and see that whether the drive is in fact malfunctioning. If it is, please refer
to chapter 4 “Hardware Installation” to replace the malfunctioning drive.
Note:
MR2 allows the data reconstruction process to be interrupted. If you turn off the power during the data
reconstruction process, the data reconstruction will continue until the next time you turn it on. Do not
change the position and order of the hard disks at will.
