MR2-B31BP Series User Manual
4
RAID 1
RAID 0
BIG
JBOD
5. RAID Mode Setting
Provide a big storage capacity and the data transfer efficiency, but no data porotection
feature.
Because of this Mirroring feature, your two HDDs/SSDs will keep an identical data after
your wtiting works. In case one of the two HDDs/SSDs is defect, MR2 would still work fine
with only one of them. And once inserting a good HDD/SSD as the defect replacement, it
will do the rebuilding work by itself.
With JBOD mode, you could actually use the two HDDs/SSDs as the normal two storages
for your large memory capacity requirement, but no data porotection feature.
You could enjoy a double memory capacity from this BIG feature, but no data porotection
feature.
RAID 0
：
RAID 1
：
JBOD
：
BIG
：
(default)
The Standard Procedure to Switch RAID Setting
1.
Please first connect MR2 to your computer.
2. When the blue light of the HDD access light is always on, please set RAID switch to JBOD.
3. Please use the key to press the RESET hole, wait for the Blue-Purple LED on the HDD access
light to finish blinking, and turn it into a solid blue light, then release the key.
4. When the blue light of the HDD access light is always on, please set RAID switch to the position
you demand.
5. Please use the key to press the RESET hole, wait for the Blue-Purple LED on the HDD access
light to finish blinking, and turn it into a solid blue light, then release the key.
6.
Please turn off your MR2, and turn it back on again. You now have reset MR2 with a new RAID
mode successfully.
