5
CLEANING INSTRUCTIONS
IMPORTANT
Stainless steel may corrode if not cleaned properly.
Clean and dry the heated bowl inside the warmer every night. Use a soft cloth and mild soap to keep
exterior surfaces bright and shining. To keep the inside surface of the bowl clean, use steel wool pads as
often as necessary. Do not use detergents, strong abrasives or metal scouring pads on exterior surface of
warmer.
DO NOT IMMERSE IN WATER AT ANY TIME.
PUMP CLEANING
Before using and at least daily, disassemble the pump and wash all parts.
To disassemble pump:
. Unscrew nut-cylinder. Pull pump-plunger from pump chamber.
2. Unscrew knob from plunger assembly and disassemble.
. Unscrew cap-tube and nut-sleeve-tube from dispense tube. Remove cover from pump
assembly.
. Remove pin "U" from pump assembly and disengage dispense tube from pump
chamber.
5. Remove balls from pump chamber.
6. Wash all parts thoroughly in hot soapy water and rinse thoroughly. Use 8" long brush
to clean inside of dispensing tube. Reassemble pump. When reassembling pump, wet
O-ring with edible vegetable oil, then reassemble. Make sure all parts are in their proper
place.
SANITIZING PUMP ASSEMBLIES
It is recommended that the pump assembly be sanitized after routine disassembly and cleaning. Prepare
a 200 ppm four part solution (similar to Pro-Quat 0). Immerse all pump parts in this solution for at least
60 seconds, remove and let air dry. Reassemble the pump.
PRIMING PUMP
Three () strokes of the pump plunger are necessary to initially prime and vend thick food products.
If pump does not dispense product properly, remove plunger assembly from pump and make sure the
plunger O-ring is in place on the pump plunger. If the O-ring is missing disassemble the pump parts and
make certain the O-ring is not in the pump plunger tube, pump chambers or vend tube before replacing
O-ring.
FAILURE TO DO THIS CAN CAUSE A BROKEN O-RING TO BE PUMPED OUT WITH
THE FOOD BEING VENDED.
SIGN REPLACEMENT
. Unplug cord from the receptacle.
2. Push front plastic panel up using a plastic pin or very small screwdriver.
. Pull forward on the bottom edge of the plastic panel and remove it.
. Replace the sign.
5. Place the front plastic panel back into its original position.
LIGHT BULB REPLACEMENT
. Unplug cord from the receptacle.
2. Remove both front panels as stated above.
. Replace bulbs with a 0 or 5 watt candelabra base for 20V or a 0 watt medium base for 20V.
CAUTION
CAUTION
Summary of Contents for 3W SERIES
Page 11: ......
