Star 11 QUART, Installation And Operation Instructions Manual

Page: 3 / 12

FOOD WARMERS WITH HEATED SPOUTS ARE ACCEPTABLE FOR POTENTIALLY HAZARDOUS FOODS.
* N - Nacho Sign, F - Fudge Sign, CD - Chili Dog Sign, BQ - BBQ Sign, C - Chili Sign, S - Soup Sign
FOOD WARMERS WITHOUT HEATED SPOUTS ARE NOT ACCEPTABLE FOR POTENTIALLY HAZARDOUS FOODS.
LIGHTED WARMER SPECIFICATIONS
Model Capacity
Electrical Dimensions
Weight Approval Agency
Volts Hz Amps Depth Width Height
11WLA
11 qt
120V
60
13.58
15.125” 13.25”
11.5” 17lbs
UL / CUL
240V 6.8
11WLA-C/UL 120V 13.6
11WLA-HS
120V 13.79
18.75”
23lbs + 240V 6.9
11WLA-HSC/UL 120V 13.6
11WLA-P
120V 13.58
22lbs 240V 6.8
11WLA-P-C/UL 120V 13.6
GENERAL INFORMATION
This equipment is designed and sold for commercial use only by personnel trained and experienced in
its operation and is not sold for consumer use in and around the home nor for use directly by the general
public in food service locations.
GENERAL INSTALLATION INSTRUCTIONS
These food warmers are equipped for the voltage and wattage indicated on the nameplate mounted to the
bottom panel and are designed for use on alternating current (AC) only.
DO NOT CONNECT TO DIRECT CURRENT (DC).
PUMP INSTALLATION
Follow these simple instructions to install the pump into the heated spout casting.
. Remove pump from warmer.
. Swing retainer fastened to the pump heater casting down.
. Press down on pump plate and turn pump counterclockwise until notches line up with bumps on
black bowl.
4. Lift pump from bowl.
5. Open tin and remove paper label.
6. Place bowl lifter spring in black water bowl with one quart of hot water.
7. Turn on warmer switch "on".
8. Pre-Heat cheese before inserting pump. Pump will not function if cheese is too thick.
9. Be sure bowl lifter spring is placed inside water bowl before inserting container.
0. Place tin or bowl into unit. Bowl lifter spring should be centered under container.
. Place pump in tin or bowl and line up notches in pump plate with bumps on black bowl.
. Press down on pump plate until notches are below bumps on black bowl. Turn pump clockwise until
pump spout engages groove in spout casting.
. Swing lever up to prevent pump spout from disengaging.
CAUTION
WARNING