Star Micronics NL-10, User Manual

Page: 2 / 35

Federal Communications Commission
Radio Frequency Interference
Statement
This equipment generates and uses radio frequency energy and if not installed and used
properly, that is, in strict accordance with the manufacturer’s instructions, may cause
interference to radio and television reception. It has been type tested and found to com-
ply with the limits for a Class B computing device in accordance with the specifications
in Subpart J of Part 15 of FCC Rules, which are designed to provide reasonable protec-
tion against such interfernce in a residential installation. However, ther is no guarantee
that interfernce will not occur in a particular installation. If this equipment does cause
interference to radeo or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient the receiving antenna
• Relocate the conputer with rewpect to the receiver
• Move the computer away from the receiver
• Plug the computer into a different outlet so that computer and receiver are on
different branch circuits.
If necessary, the user should consult the dealer or an experienced radio/television tech-
nician for additional suggestions. The user may find the following booklet, prepared by
the Federal Communications Commission helpful: “How to Identify and Resolve Ra-
dio-TV Interference Problems.” This booklet is available from the U.S. Govertnment
Printing Office, Washington, D.C., 20402, Stock No. 004-000-00345-4.
For compliance with Federal Noise Interference Standard, this equipment requires a
shielded cable.
This statement will be applied only for the printers marketed in U.S.A.
Self Declaration
Radio interferences regarding this equipment has been eliminated according to Vfg
1046/1984 announced by the DBP.
DBP has been informed about the introduction of this special equipment and has been
conceded the right to examine the whole series.
It is upon the responsibility of the user to assume that his own assembled system is in
accordance with the technical regulations under Vfg 1046/1984.
To observe FTZ-regulations it is necessary, to establish all connections to the printer
with shielded cable.
The equipment may only be opened by qualified service representatives.
This statement will be applied only for the printers marketed in West Germany.
Trademark Acknowledgement
NL-10: Star Micronics Co., Ltd.
NOTICE
• All rights reserved. Reproduction of any part of this manual in any form whatso
ever, without STAR’S express permission is forbidden.
• The contents of this manual are subject to change without notice.
• All efforts have been made to ensure the accuracy of the contents of this manual at
the time of going to press. However, should any errors be detected, STAR would be
greatly appreciate being informed of them.
• The above notwithstanding, STAR can assume no responsibility for errors in this
manual.
Copyright 1985 Star Micronics Co., Ltd.