-
9 -
3-3. Bluetooth Settings
(For Bluetooth Models only)
Pair the printer with the master device by following the procedure below.
Note1: Make sure the Dip switch 1-1 is on.
2: Please pay attention to your external environments to secure the pairing of DK-AirCash with the specified mas-
ter device.
3-3-1. Pairing using SSP (Simple Secure Pairing) [Default]
①
After turning the DK-AirCash's power switch on, press and hold the PAIR button for 5 seconds or more, and then release
it. The LED will flash green.
②
Pairing will be possible for 60 seconds from when the LED begins flashing green. During this time, perform pairing
from the master device.
Device name:
Star Micronics (default)
③
After performing pairing, wait until the LED stops flashing blue, or turn the DK-AirCash off and back on again, to enable
the connection. With some master devices, after pairing, the LED will automatically begin flashing blue, and the printer
will be automatically connected.
④
Confirm the connection by operating from the master device application.
3-3-2. Pairing using PIN code
Enter the following information in the master device if it does not support SSP, or when otherwise necessary.
PIN Code:
1234 (default)
Device name:
Star Micronics (default)
Note: It is recommended that you change the PIN code for greater security.
Use the exclusive setting utility to the PIN code settings.
For more information about setting utility, refer to the following website.
http://www.star-m.jp/eng/dl/dl02.htm
3-3-3. Resetting Bluetooth Settings
The PIN code, device name, and other settings can be reset by following the procedure given below.
①
Make sure that the AC adapter’s power cord is not connected to the outlet.
②
DSW1-3 Off, connect the AC adapter, turn the power On.
③
When the initialization starts, the DK-AirCash's POWER and ERROR lamps flashes.
④
When initialization is finished, the POWER and ERROR lamps stops flashing.
⑤
Turn the power Off, unplug the AC adapter's power code, DSW1-3 On.
⑥
Delete the pairing settings of the paired device.
⑦
Restart the paired device or terminate the application.
⑧
Connect the power cord according to the procedure in section 3-4 “Connecting the AC Adapter”, turn the power On
again and establish pairing connection.
