7
COMPLETE SHUTDOWN INSTRUCTIONS
Turn the burner valve knobs to the OFF position to
turn burners off and close manual valve gas shutoff.
CLEANING
Clean regularly. Be sure appliance has cooled down.
Remove grate section and burner head to sink for
washing. Brush out carboned particles. Venturi must
be free from grease, dirt, lint, or any foreign material.
Remove and wash crumb pan.
Be sure to replace
top grates laying flat and centered over the burner.
Wipe exterior surfaces with a mild detergent and a
cloth. A non-abrasive cleaner can be used on caked
areas. Be careful with spraying on some cleaners as
they may contain abrasives and caustics which could
scratch or damage the finish.
BURNER IGNITION AND ADJUSTMENT
1. To ignite burners turn burner valve knob counter
clockwise to "ON"position.
2. Slowly decrease openings of air shutters to give a
soft blue flame having luminous tips, then slowly
increase openings to a point where the yellow tips
disappear and a hard blue flame is obtained.
LIGHTING
When hotplate is first lit, it may smoke for
approximately 20-30 minutes until the preservation
oils and impurities are burned off.
OPERATING INSTRUCTIONS
BOTTOM CRUMB PAN
The crumb pan is located at the bottom of the unit, and
is easily removed from the front of the unit for
cleaning. Be sure it is in place during operation.
BURNER OPERATION
Each burner is controlled by an individual on-off valve.
A variety of temperatures may be obtained by turning
the burner valve knob to any position between ON
and OFF. It is possible through this arrangement to
have a high heat section, while having a low heat
simmering or holding section. For the high heat
operation, turn the valve counter clockwise for the
section to a position of ON or close to it. For holding
or simmering, turn the valves closer to the OFF
position on the dial. If even less heat is required, the
valve may be turned OFF and the product kept warm
on the pilot flame. You select the heat pattern you like
and set the valves accordingly.
Be sure burners are
staying fully lit when set in low positions.
RETAIN THIS MANUAL FOR FUTURE REFERENCE
Part No. 2M-Z7923
Rev. -- 6/1/04
Summary of Contents for 8I-802H-LP
Page 9: ...9 ...