Star Headlight & Lantern STARSIGNAL LCS771, Installation And Operating Instructions Manual

Page: 9 / 16

-7-
Optional Tone Programming
The LCS771 will produce 7 different tones/sounds by activating its various functions:
Function Default Tone
Phaser Step Up
(PHSR+MAN)
Two-Tone
PHSR Phaser
YELP Yelp
WAIL Wail
MAN Ramp Up
HORN Air Horn
AUX Air Horn
Proceed below if you wish to reprogram
any of these functions for a different tone.
1. Power up the unit.
2. Activate the function you wish to change.

For PHSR, WAIL, and YELP functions, rotate the selector knob into the
corresponding position.

For the MAN, HORN, or AUX functions, rotate the selector knob into the
MANUAL or ALERT position, then press
and hold the MAN button, HORN
button, or steering wheel horn , respectively.

For the Phaser Step Up function , rotate the knob into the PHSR position, then
press and release the MAN button.
The tone currently programmed for that function will sound.
Tone Program Button 3. The Tone Program button can be found above the DIP
switches on the rear of the siren. Using a paper clip, press and
release it to cycle through the list of optional tones.
Review
the chart below for the list of optional tones.
4. De-activate the function to save the new tone.
1 WAIL (Wail default) §, *, †
2 YELP (Yelp default) §, *
3 PHASER (PHSR default)
4 TWO-TONE
(PHSR Step Up default)
5 MECHANICAL WAIL
(FIRE ENGINE)
†
7 HOOT
8 RAPID HOOT
9 AIR HORN & YELP
10 GHOST
11 RAPID GHOST
12 SINGLE AIR HORN
13 SINGLE QUICK
14 DOUBLE POST POP AIR HORN
15 TWO TONE AIR HORN
16 STANDARD AIR HORN
Tones For WAIL, YELP, and PHSR,
and Phaser Step-Up Function
6 MAX YELP §, *
17 CONTINUOUS TONE
18 CONTINUOUS BEEP
Tones For MAN Button and AUX Wire
1 STANDARD AIR HORN (AUX default)
2 LOW FREQUENCY AIR HORN
3 RAPID AIR HORN
4 AIR HORN II
5 DOUBLE POST POP AIR HORN
6 SINGLE AIR HORN
7 SINGLE QUICK AIR HORN
8 TWO TONE AIR HORN
9 MANUAL (MAN default) *
10 MECHANICAL MANUAL
(FIRE ENGINE)
Tones for Horn Button
1 STANDARD AIR HORN (default)
2 LOW FREQUENCY AIR HORN
3 RAPID AIR HORN
4 AIR HORN II
5 DOUBLE POST POP AIR HORN
6 SINGLE AIR HORN
7 SINGLE QUICK AIR HORN
8 TWO TONE AIR HORN
►►►►
System Reset
◄◄◄◄
If you would like to reset ALL of the siren programming
options to their defaults, activate any tone and press
the
Program button for nine (9) seconds. The LED will
flash once, then twice, then three times, and all siren
tones will stop.
Optional Tones
§ = SAE approved
* = California Title 13 approved when configured properly
† = See next page
(Installer Selectable Options CONT’D)