-4-
Wiring
For proper installation and full operability, this light requires a 20A ignition switched power
source, connections to the negative terminal of the battery, and 4-6 external switches rated
for a minimum 1A
(user supplied)
.
These lights come with a pre-installed 8-conductor harness. In addition, the cable also
contains a bare drain wire and foil shielding.
BLACK
BARE
White w/Brown - Pursuit (Flashing White Lights) or TD Warn
Green w/Yellow - Takedowns (Steady Burn White) or TD Left
Yellow - California Title 13 Lights (Steady Red) or TD Right
Green w/Red - Pattern Select or Dim
Red - Ignition Sw12VDC
User Supplied Switches
Orange w/Red - Level 2 Flashing Warning Lights
Orange w/Green - Level 1 Flashing Warning Lights
+12VDC
+12VDC
+12VDC
+12VDC
+12VDC
+12VDC
+
-
20 AMP
FUSE
Quick Wiring Guide
All wires connected to the positive terminal of the battery should be fused at the
battery for their rated load.
Testing the light before this fuse is properly
installed will void the warranty on the light.
Please Note:
When the red wire is connected to +12VDC the light will draw a
small current (2 mA). Occasionally vehicles may sit for extended
periods of time (i.e. more than a few days), thus we recommend that
the red wire be routed through an ignition switched power source.
