-1-
Permanent Mounting
1. Carefully remove the lightbar and the direct mount kit included with the bar from its
shipping carton.
2. Slide the eight enclosed carriage bolts into the channels running underneath the lightbar.
Use four stove bolts for each mounting bracket.
3. Position one bracket on the four bolts at each end of the lightbar and secure both
brackets with one flat washer, one lock washer, and one hex-nut on each bolt.
ROOF OR
MOUNTING SURFACE
FOAM GASKET
4. Carefully place your lightbar in position onto the roof of the vehicle while using the foot
gasket or a pad to protect the roof from scratches. The tabs on the mounting brackets
can be bent slightly to an angle that matches the curvature of the roof.
5. Using the mounting bracket feet as
templates, mark the areas for the holes
to be drilled.
6. Remove the lightbar, and drill holes in
the roof of the vehicle.
CAUTION:
Take care not to drill through the
headliner below.
Remove any burrs.
7. Use the two foam gaskets attached to
each leg. Place them between the leg
and the roof of the vehicle and attach
the lightbar and brackets to the vehicle
using four suitable fasteners obtained
locally.
Magnet Mounting
If you are mounting the light on the roof of your vehicle, take extreme care to ensure that
the magnets are firmly seated on your roof, and that the pull of the magnets is sufficient to
secure the light in place. Since the composition of the metal in the roofs of different
vehicles may vary, as well as the contour, texture and/or condition, Star cannot guarantee
the ability of the light to remain in place upon a moving vehicle.
It is the sole
responsibility of the owner to ensure the warning light is secure.
