Stanton T.92 USB, User Manual

Page: 6 / 16

16. ANTI SKATE KNOB -
When a record is playing, a centrifugal force is
generated drawing the stylus towards the center of the record. This
control compensates for that force and needs to be set to the same
value as the counter weight pressure ring. See “Tonearm and
Cartridge Settings” instructions for more information.
17. TONE ARM BASE -
The tone arm base includes tone arm rest.
18. COUNTERWEIGHT - Use this to balance the tone arm and to adjust
the stylus pressure. See “Tone Arm And Cartridge Settings” for
proper adjustments.
19. 45-RPM ADAPTOR HOLDER -
Place the attached 45-rpm adaptor
here. Push down the rear side of 45 rpm adaptor to take it off.
20. EXTRA HEADSHELL HOLDER -
Place extra headshell here.
21. PHONO/LINE OUTPUT L & R -
This is the standard analog output
(RCA jacks) which can be connected either to a phono or line input on
any DJ mixer or stereo system, depending on the setting of the phono
/ line selector.
22. PHONO/LINE SWITCH -
Switches the output to either phono or line
level. Use the PHONO setting when plugging into a “PHONO” input
on a receiver or DJ mixer. Use “LINE” position when connecting to a
line level input such as CD or VCR on a receiver.
WARNING – Never connect a line level output (LINE position) to
a PHONO input on a receiver or DJ mixer.
23. USB SOCKET-
Connect the USB cable (included) to this socket and
to a USB connector on your computer. After connecting the turntable
to your computer, you can record your vinyl to your hard disk using
the included iZotope software.
Note: maximum USB cable length is 3m
24. DIGITAL OUTPUT -
Use this output to connect your T.92 USB to the
S/PDIF digital input of any equipped digital device, such as a CDR or
computer soundcard
25. POWER CORD CONNECTOR -
Used to connect the included power
cord.
26. POWER SWITCH -
This switch turns the power on or off, including
the motor and audio signal. Use this switch when the unit will not be
active for extended periods of time.
CONTROLS OVERVIEW
5
5