TE C H N I CA L S P E C I FI C AT I O N S
Line inputs:
2
(RCA),
150
mV /
47
K ohm
Phono inputs:
2
(RCA),
3
mV /
47
K ohm
DJ mic input:
1
(1/4 inch),
1.6
mV /
600
ohm
Master output:
1
(RCA),
1
V /
600
ohm
Record output:
1
(RCA),
350
mV /
600
ohm
Headphone output:
1
(1/4 inch),
32
-
200
ohms recommended
Frequency Response:
20
Hz -
20
kHz, +/- 0
.5
dB
Tone Control :
+
9/-26
dB (Hi, Mid, Low)
Mic Tone:
Hi/Mid/Lo
+/-12
dB
Gain Control:
0-20dB
S/N Ratio:
Less than 80dB
T.H.D:
0.01%
at
1KHz
Dimension(LxWxD):
8.6” x 12.2” x 3.94” (220 x 310 x 100 mm)
Weight:
8 Lbs (
3.5
Kg) power supply included
C RO S S FA D E R C LE A N I N G
The PRO-30 crossfader may need lubrication from time to time. This will extend
the fader life and eliminate any potential damage due to extended heavy usage.
Cleaning Instructions
1. Remove the crossfader by unscrewing the 2 outer screws (removing the 2
inner screws will detach the fader from the fader plate) and disconnecting the
cable from the mixer.
2. Spray a small amount of cleaner or lubricant into both ends of the fader and
slide the fader back and forth a few times to spread the fluid evenly throughout
the fader.
3. Shake and wipe off excess fluid before re-assembling the fader.
C RO S S FA D E R R E P L AC E M E N T
To replace the cross or channel faders, follow step 1 of the cleaning instructions.
Replacement parts are availabe from Next! or your local Next! dealer.
WA R R A N T Y
This unit has been designed and manufactured using quality
components. Therefore, it is warranted to be free from defects in materi-
als (limited as specified below), and workmanship for a period of thirty
six (36) months from the original purchase date. During this period, all
service and parts necessary to repair a defect will be free of charge. This
limited warranty applies to mechanical parts which are subject to wear
and tear as specified:
• Faders, specified durability: 15,000 cycles
• Rotary potentiometers, specified durability: 10,000 cycles
• Switches, specified durability: 10,000 cycles
Consequently, the parts listed above are warranted to be free from
defects in materials and workmanship for a period of thirty days (30)
days from the original purchase date.
FOR THE WA R R A N TY TO BE VA LID, PLEASE CO M PLE TE THE
O N LINE WA R R A N TY REGIST R ATION FORM FOUND AT
W W W. STA N TO N M AG N E TI CS . CO M
2821 Evans Street • Hollywood, FL 33020
