Stanley STEL785, Manual

Page: 5 / 12

5
ENGLISH
Features (Fig. A)
1. On / off switch
2. Lock-on button
3. Depth-of-cut adjustment lever
4. Base
5. Brush Cap
6. Socket wrench
7. Spanner
Assembly and Adjustment
Prior to assembly and adjustment always unplug the
tool.
Fitting & Removing the Diamond Wheel (Fig. C)
Fitting
Insert the diamond wheel (9) to the spindle.
Grip outside flange with spanner (7) and turn socket
wrench (6) counterclockwise.
Be sure to tighten clamp bolt securely.
Use only the recommended diamond wheel with the
correct hole size.
Removing
Follow the procedure above in reverse order.
Cutting Depth Adjustment (Fig. D)
To increase or decrease the depth of cut, loosen by
pulling the Depth-of-cut adjustment lever (3) down.
For minimum depth of cut, move/slide wing nut
towards the "-" sign.
To increase the depth of cut, move adjustment lever
upwards, away from the base.
At the desired depth of cut, secure the base by
tightening the adjustment lever.
At anytime, the depth-of-cut adjustment knob can
also be set to a desired position to suit the user.
Instruction for Use
Always observe the safety instructons and applicable
regulations.
Ensure that the depth-of-cut adjustment lever (3) is
properly tightened before operating the tool.
Switching On And Off (Fig. E)
To switch the tool on, press the on/off switch (1).
To switch the tool off, release the on/off switch.This
tool has a lock-on feature.
To activate press the on/off switch and the then
lock-on button (2).
To de-activate press the on/off button again.Always
switch off the tool when work is finished and before
unplugging.
Cutting (Fig. E)
Align the edge of the front of the base with the
cutting line on the work piece.Hold the tool firmly.
Set the base on the work piece to be cut without the
wheel making any contact.
Turn tool on and wait until the wheel attains full
speed.
Move the tool forward over the work piece surface,
advancing smoothly until the cut is completed.
Keep the cutting line straight.
This tool should only be used on horizontal
surfaces.
Be sure to move the tool gently forward, in a straight
line. Forcing, or exerting excessive pressure, or
allowing the wheel to bend, pinch or twist in the cut
can cause the motor to over heat and tool to
kickback dangerously.
When cutting the work piece over 20mm deep,
make 2 or 3 separate cuts to prevent motor
failure.
Maintenance
Your Stanley power tool has been designed to operate
over a long period of time with a minimum of
maintenance. Continuous satisfactory operation depends
upon proper tool care and regular cleaning.
Motor Brushes (Fig. F)
Remove and check carbon brushes regularly.
Replace when they have worn down to about 6mm
or less.
Keep carbon brushes clean for free movement in the
holder. Both carbon brushes should be replaced at
the same time.
Use only Stanley carbon brushes.Use a screwdriver
to remove brush caps (5).
Take out worn brushes, insert new ones, and secure
the brush caps.
Cleaning
Warning:
unplug the tool before you use a cloth to
clean the housing. With the motor running, blow dirt and
dust out of all air vents with dry air at least once a week.
Wear safety glasses when performing this. Exterior
plastic parts may be cleaned with a damp cloth and mild
detergent. Although these parts are highly solvent
resistant, NEVER use solvents.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•