Stanley RD60, Operator'S Manual

Page: 19 / 40

GENERAL INFORMATION
RD60 is a battery powered rail drill that cycles automatically. With a D
E
WALT FLEXVOLT battery and the
included hand pumped coolant canister, the RD60 can be used easily in places where hydraulic tools
may be difficult to operate.
Read all safety warnings, decals and operating instructions before operating the tool. If there is any
portion of this manual that you do not understand, contact your dealer.
WARNING!
READ MANUAL PRIOR TO INSTALLATION
Improper installation, operation, or maintenance of this equipment could result in serious
injury or death. Operators and maintenance personnel should read this manual, as well as
all manuals related to this equipment thoroughly before beginning installation, operation,
or maintenance.
FOLLOW ALL SAFETY INSTRUCTIONS IN THIS MANUAL.
DISCONNECT BATTERY
Do not install, change tool accessories, clean or perform maintenance on the tool while
the battery is connected to the tool. Remove the battery from the tool before performing
maintenance.
ACCIDENTAL ENGAGEMENT OF THE TOOL CAN CAUSE SERIOUS INJURY.
CHARGE BATTERY
1. Place the charger on a firm surface and ensure the vents are not covered.
WARNING!
DO NOT EXPOSE THE CHARGER TO RAIN OR SNOW
Do not immerse the charger in water or any other liquid. Place the charger in a clean, dry
space during use.
IMPROPER USE OF THE CHARGER COULD RESULT IN RISK OF FIRE, ELECTRIC SHOCK
OR ELECTROCUTION.
2. Plug the charger into a standard 120V household electrical outlet.
3. Insert the battery pack into the charger. Ensure the battery pack is fully seated in the charger.
Only use battery packs and chargers that have been recommended by STANLEY.
NOTE
The red light on the charger will blink, indicating that the charging process has started.
4. When the red light remains on continuously, the battery pack is full.
62211 | February 2022 | 19
Installation