8
9
IMPORTANT
FUEL - ONLY USE UNLEADED PETROL (ULP)
Fuel tank capacity – 3.6 litres (3.6 L)
Use of incorrect fuel and/or oil may damage the pressure washer and will not be covered under warranty.
Do not use E10 or any type of ethanol fuel as this will damage the pressure washer and will not be covered under warranty.
Do not use high octane fuels (greater than 91%) as this will damage the pressure washer and will not be covered under warranty.
• Ensure you use clean fresh unleaded petrol (ULP).
• Use a clean approved container to store your unleaded petrol (ULP) in before decanting into the fuel tank.
• If contaminated (dirty) or old (stale) fuel is used any damage caused will not be covered under warranty.
OIL
To operate, this pressure washer requires oil in the sump, not supplied. If the pressure washer does not have the
correct level of oil in the sump, it will not run, see note below.
Oil capacity – approximately six hundred millilitres (0.6 L or 600 ml)
Oil type – SAE 30W or SAE 15W-40
• Always check oil level before using.
• Always use fresh clean oil.
• Change oil every 50 hours or every 3 months.
• If contaminated (dirty) or old (stale) oil is used any damage caused will not be covered under warranty.
NOTE: This pressure washer is fitted with an oil cut out switch. If the oil level is empty or low then the pressure washer WILL
NOT start or run.
Always check the oil level before starting the pressure washer.
Never check or add oil while the pressure washer is running.
