ID07 User Manual | 13
Carbide Tipped Wood Auger Bits - 7/16 Inch Hex
Ø
Length
Overall
Length
Part Number
13/16 Inch
8 Inch
12 Inch
27852
15/16 Inch
8 Inch
12 Inch
27853
1 1/16 Inch
8 Inch
12 Inch
27854
9/16 Inch
12 Inch
16 Inch
27855
11/16 Inch
12 Inch
16 Inch
27856
13/16 Inch
12 Inch
16 Inch
27857
15/16 Inch
12 Inch
16 Inch
27858
1 1/16 Inch
12 Inch
16 Inch
27859
9/16 Inch
18 Inch
22 Inch
27860
11/16 Inch
18 Inch
22 Inch
27861
13/16 Inch
18 Inch
22 Inch
27862
15/16 Inch
18 Inch
22 Inch
27863
1 1/16 Inch
18 Inch
22 Inch
27864
13/16 Inch
36 Inch
48 Inch
27869
Troubleshooting
Problem
Possible Cause
Solution
Tool will not start, is
running too fast or too
slow.
The hydraulic power
source is not running
or not running
properly.
Ensure the power
source is delivering
proper flow and
pressure. See
“Specifications” on
page 11. Proper
flow and pressure
maintain proper tool
speed. Check regularly.
Tool has low impact
performance.
The hydraulic power
source is not running
or not running
properly.
Ensure the power
source is delivering
proper flow and
pressure. See
“Specifications” on
page 11. Proper
flow and pressure
maintain proper tool
speed. Check regularly.
Hydraulic hoses are
reversed.
Install hydraulic hoses
properly. See “Connect
to a Hydraulic Power
Source” on page 11.
Defective quick
disconnects.
Inspect for damage or
blockage. Replace if
necessary.
Incorrect grease in the
impact mechanism
or the mechanism
maintenance hasn’t
been performed.
Grease the impact
mechanism. See
“Grease the Impact
Mechanism - Detail E”
on page 12.
Motor or impact
mechanism failure.
Contact your STANLEY
dealer for service.
Hydraulic oil is too hot
or the hydraulic power
unit is working too
hard when running the
tool.
Hydraulic circuit type
set incorrectly.
Ensure the hydraulic
circuit type on the tool
is set to match your
hydraulic system. See
“Set Hydraulic Circuit
Type - Detail C” on
page 11.
Hydraulic power source
is not running properly.
Ensure the power
source is delivering
proper flow and
pressure. See
“Specifications” on
page 11. Proper
flow and pressure
maintain proper tool
speed. Check regularly.
Relief valve is set too
low.
Ensure your hydraulic
system relief valve
is set properly. See
“Specifications” on
page 11.
Oil is leaking from
the reversing spool or
motor cap.
Hydraulic hoses
incorrectly connected
to the tool.
Ensure the return and
pressure hoses are
properly attached to
the tool. See “Connect
to a Hydraulic Power
Source” on page 11.
Damaged O-Rings,
loose fasteners or
other damage.
Contact your STANLEY
dealer for service.
