6
ENGLISH
(Original instructions)
Note:
This could also mean a problem with a charger. If the
charger indicates a problem, take the charger and battery
pack to be tested at an authorized service centre.
Leaving the battery in the charger
The charger and battery pack can be left connected with the
LED glowing indefinitely. The charger will keep the battery
pack fresh and fully charged.
Hot/Cold Pack Delay
When the charger detects a battery that is too hot or too cold,
it automatically starts a Hot/Cold Pack Delay, the green LED
(5a) will flash intermittently, while the red LED (5b) will remain
on continuously, suspending charging until the battery has
reached an appropriate temperature. The charger then
automatically switches to the pack charging mode. This
feature ensures maximum battery life.
Battery state of charge indicator (Fig. B)
The battery includes a state of charge indicator to quickly
determine the extent of battery life as shown in figure B. By
pressing the state of charge button (4a) you can easily view
the charge remaining in the battery as illustrated in figure B.
Installing and Removing the Battery Pack from the
tool
To install battery pack (Fig. C)
u
Insert battery pack firmly into tool until an audible click is
heard as shown in figure C. Ensure battery pack is fully
seated and fully latched into position.
To remove battery pack (Fig. D)
u
Depress the battery release button (4b) as shown in figure
D and pull battery pack out of tool.
Storage hook (Optional extra) (Fig.E)
Warning!
To reduce the risk of serious personal injury, ensure
the screw (6) holding the storage hook is secure.
Note:
When attaching or replacing the storage hook (7), use
only the screw (6) that is provided. Be sure to securely tighten
the screw.
If the hook is not desired at all, it can be removed from the
tool.
To move the storage hook, remove the screw (6) that holds
the storage hook (7) in place.
Note:
Various trackwall hooks and storage configurations are
available.
Please visit our website www.stanley.eu/3 for further
information.
Use
Warning!
Let the tool work at its own pace. Do not overload.
Switching on and off
u
To switch the light on press in the switch (1)
u
To switch the light off press in the switch (1)
The pivoting lens (fig. F, G)
u
For your convienience, the lens can be pivoted into a
range of positions.
u
Turn the pivoting LED wheel (3) anti clockwise and posi-
tion the Lens (2) as required.
Note:
The area light has 2 brightness levels. Continue to
press the on/off switch (1) to cycle from OFF-HI-LO
brightnesses.
Maintenance
Your Stanley FatMax tool has been designed to operate
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.
Your charger does not require any maintenance apart from
regular cleaning.
Warning!
Before performing any maintenance on the tool,
remove the battery from the tool. Unplug the charger before
cleaning it.
u
Regularly clean the ventilation slots in your tool and
charger using a soft brush or dry cloth.
u
Regularly clean the motor housing using a damp cloth.
u
Do not use any abrasive or solvent-based cleaner.
u
Regularly open the chuck and tap it to remove any dust
from the interior.
Protecting the environment
Z
Separate collection. Products and batteries
marked with this symbol must not be disposed of
with normal household waste..
Products and batteries contain materials that can be recov-
ered or recycled reducing the demand for raw materials.
Please recycle electrical products and batteries according to
local provisions. Further information is available at
www.2helpU.com
