Stanley FatMax FME720, Manual

Page: 11 / 144

@
Warning! Never use abrasive wheels.
Safety of others
● This tool is not intended for use by persons (including
children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction
concerning use of the tool by a person responsible for
their safety.
● Children should be supervised to ensure that they do not
play with the appliance.
Vibration
The declared vibration emission values stated in the technical
data and the declaration of conformity have been measured in
accordance with a standard test method provided by EN62841
and may be used for comparing one tool with another. The
declared vibration emission value may also be used in a
preliminary assessment of exposure.
@
Warning! The vibration emission value during
actual use of the power tool can differ from the
declared value depending on the ways in which
the tool is used. The vibration level may increase
above the level stated.
When assessing vibration exposure to determine safety
measures required by 2002/44/EC to protect persons regularly
using power tools in employment, an estimation of vibration
exposure should consider, the actual conditions of use and the
way the tool is used, including taking account of all parts of the
operating cycle such as the times when the tool is switched off
and when it is running idle in addition to the trigger time.
Labels on tool
The following symbols are shown on the tool along with the
date code:
:
Warning! To reduce the risk of injury, the user
must read the instruction manual.
Electrical safety
#
This tool is double insulated; therefore no
earth wire is required. Always check that the
power supply corresponds to the voltage on the
rating plate.
● If the supply cord is damaged, it must be replaced by
the manufacturer or an authorised STANLEY FATMAX
Service Centre in order to avoid a hazard.
Features
This tool includes some or all of the following features.
1. Laser on/off switch
2. Main operating handle
3. On/off switch
4. Motor housing
5. Moveable lower guard
6. Table extension material stop (right)
7. Table extension (right)
8. Kerf plate
9. Mitre clamp
10. Mitre lock knob
11. Mitre detent lever
12. Mitre position adjustment pointer
13. Mitre scale
14. Rotating table
15. Bench mounting holes
16. Clamp locating mounts
17. Table extension (left)
18. Table extension material stop (left)
19. Table extension securing knob
20. High sliding fence clamp
21. Left-hand fence
22. Left-hand high sliding fence
23. 33.9° bevel pin
24. Rear carry handle
25. Saw dust outlet
26. Metal upper guard
27. Front carry handle
28. Removable brush box
29. Carriage
30. Bevel lock handle
31. Bevel scale
32. Right-hand fence
33. Laser
34. Saw blade
35. Spindle lock button
36. Saw arm release lever
Fig. R
53. Clamp
Assembly
@
Warning! Before assembly, make sure that the
tool is switched off and unplugged.
Note: This tool is accurately adjusted before shipping from
the factory. Check the following accuracy and readjust them if
necessary in order to obtain the best results in operation.
Laser beam
The laser beam alignment is set at manufacturing source and
is not user adjustable.
Mitre angle adjustment
The sliding compound mitre saw scale can be easily read
showing mitre angles from 0° to 47° to the left and the right.
The most common angle cut setting slots have positive stops,
permitting fast adjustments to the required position. Follow the
process below for quickest and most accurate adjustments.
11
ENGLISH (Original instructions)