Before setting
You must see
ALARM
HOLD
Before setting
You must see
ALARM
MON
©2008-2011 Stanley Security Solutions, Inc. DOC-02-70001-AA
800-523-7956 | Fax 402-475-4023 | www.bedcheck.com
Quick Programming Guide
continued
Model Vr
3. HOlD TIME
(bypass this step by pressing reset)
This setting determines the elapsed time (in seconds) from the moment
the control unit senses the patient’s weight on the Sensormat pad until
monitoring begins.
Use the
button to change this time from 1-9 seconds.
Press RESET to move to Step 4.
4. VOluME cONTROl
(bypass this step by pressing reset)
This setting controls the alarm volume. Use the
button to adjust volume from 0-9.
1 is low volume, and 9 is maximum volume. 0 will mute the control unit, but the alarm
will still trigger the nurse call system (if it is in use).
Press RESET to exit the Programming Mode
.
You have completed programming of the Model Vr.
The only remaining setting is Delay Time, which may be se-
lected at any time without entering the Programming Mode required for other settings.
cHANGE DElAY TIME
(time From weight oFF sensormat pad until alarm)
The number displayed indicates the number of seconds. Change the delay time as desired (1-9 seconds; 3 is typi-
cal) using the
button.
To ensure the Model Vr retains your setting changes, unplug the power cord (either end) for 2-3 seconds
and plug it back in. This locks in your settings, which will be retained even after power interruptions.
Your Bed-Check Model Vr is now ready to monitor your fall risk individual
as soon as the Sensormat pad is properly placed and connected, and the
nurse call system is connected (if used).
