Blue Nebula User Guide, Firmware Revision 4
Page | 5
Tip: In the Echomatic II Classic emulation P1 controls the combined echo level of Heads 1, 2 and 3, not the
overall Dry/Wet mix. This means you can adjust the H123 level but the H4 level will still be taken from the
value stored in the patch.
EDITING A USER PATCH
Blue Nebula can store a total of 128 User Patches, numbered from
0
to 127. Each patch can be given a
name (up to 16 characters) and can use any of the 16 available effects. Each effect has three parameters
which can be set using the parameter knobs P1, P2 and P3 and these settings are stored in the patch.
To edit a User Patch hit the
Edit
button and the LCD will show the effect currently being used by the
patch:
You can change this if you wish by this using the
UP
and
DOWN
buttons to select any of the 16 effects
available in the Blue Nebula. With the required effect displayed hit the
OK
button to select it and the
top line of the display will now show the
names of the effect’s parameters with the
current values of the
three parameter adjust knobs P1, P2 and P3 on the bottom line:
The ^ and
characters that you may see beside each number indicates if the parameter knob value is
currently lower (^) or higher (
) than the value currently stored with the patch. Think of the arrow as an
indicator telling you to increase (^) or decrease (
) the control setting to match. You can ignore these
