Stanford MM3126, Owner'S Operating Manual

Page: 19 / 32

１８
counterclockwise while the nut is held with the wrench. (See Figure 15.)
3. If the conveyor feed belt is tracking towards the inboard (motor side) of the
machine, tighten (add tension) to the tracking adjustment screw on that
side of the machine.
NOTE: Due to the width of the conveyor feed belt, tracking adjustments
may not become apparent immediately! Increase the speed of the
conveyor feed belt to hasten the effects of your adjustments. Make small
measured corrections of approximately 1/4 turn increments and evaluate
the results. RE-adjust as necessary until the proper tracking solution is
found.
HELPFUL HINT
Tighten the side opposite the desired tracking direction. For example,
tighten the right side tracking adjustment to make the conveyor feed belt
track left.
OPERATING INSTRUCTIONS
WARNING:
Never put your fingers into port or under drum cover.
CAUTION: To avoid damage to your Drum Sander, adequate dust collection
must be used during sanding operations. A 63.5mm port is included in the
sanding drum dust cover for connecting dust collection unit/hose to your Wide
Drum Sander.
DRUM HEIGHT CONTROL
The height of the drum is raised by turning the height control knob (refer to
Figure 2) in a clockwise direction. To lower the drum, turn the height control
knob in the
counterclockwise direction. The depth of the movement is
approximately 0.4mm per 1/4 turn in either direction. One complete turn is
1.6mm. Depth settings can be measured using the depth indicator scale
located on the right side of the drum support frame.
NOTE: Depth settings used during surface sanding of stock are adjusted
by considering several variables. The hardness of the material, the width